Watertight working joints
The innovative AquaproofX® 1 joint sealing sheet is an addition to the sealing systems manufactured and supplied by StekoX® GmbH Abdichtungstechnik.
AquaproofX® 1 is used to seal all the typical working and programmed fracture joints that occur in building work (site-mixed concrete, semi-prefabricated elements, cavity walls). Examples of its application are the transition from the floor slab to the walls or at joints between two walls. Using a special connector, AquaproofX® 1 joint sealing sheet can also be attached without tools to an expansion-joint tape. It is resistant to all organic effluents and withstands a water pressure of up to 7 bar (test rapport issued by the German building authorities).
Easy to install
To obtain a permanent connection between joint plate and concrete, AquaproofX® 1 has a polymer coating on one side. It forms an extremely tight bond with the concrete and makes the joint watertight. StekoX® supplies AquaproofX® 1 as a roll (length: six metres) or as strips (two metres), as a pre-formed corner or formwork element. To make installation quick and straightforward, the manufacturer also supplies a wide range of fasteners. The BiegeFix strap, for instance, is produced specifically for use with AquaproofX® 1 on site-mixed concrete constructions, so that binding wire is not needed. This can save up to 50 % of the time involved. Bonded butt joints between elements can be made regardless of weather conditions.
AquaproofX® 1 joint sealing sheet is easy to handle, and produces watertight working and programmed fracture joints.
Vertical and horizontal joints can be connected after removal of the protective foil.
The foil is removed completely before the second stage in the concreting process.
TEL:0049/711/707095-0
FAX:0049/711/707095-25